Modern heating systems are highly reliable and sophisticated appliances, but they may break down at some point, and you may need to call up for a furnace repair in Flower Mound. This article will guide you through the five common reasons for a heater breakdown and the follow-up solutions for it.
Heater Not Working? Here Are 5 Common Reasons
A Faulty Thermostat
When you encounter a sudden spike in utility bills, you must understand that your thermostat might be malfunctioning.
When your thermostat goes out of order, you must ideally replace it with a programmable one. A programmable thermostat enables you to adjust the temperature according to your convenience, reducing your utility charges.
Low Level of Refrigerant
When the refrigerant level of your heat pump goes down, there is a significant spike seen in the utility bills. If the level continues to remain low for a longer period, then the compressor of the setup starts to overheat. Overheating leads to a breakdown.
In this situation, all you need to do is, recharge your refrigerant with the assistance of a licensed HVAC technician dealing with HVAC repair in Flower Mound TX.
Poor Design of Ductwork
If your ductwork is poorly designed, your heating system most likely faces a short cycle. At times, faulty ductwork is the main issue due to which the heater doesn’t function properly.
The only solution to this is to contact professional HVAC technicians and complete a ductwork redesign.
Poor Maintenance
Your Heating system needs to go through maintenance at least twice a year. Negligence towards the same can lead to untimely breakdowns or unwanted sounds. Unclean air filters can prove to hinder airflow and reduce the system’s efficiency. That is the reason why you must replace them after every three months.
Lack of maintenance can also result in a dirty flame sensor. This causes a hindrance in lighting the burners. A dirty flame sensor then cuts off the working, as it cannot sense the flame burning.
To avoid these problems, you need to call up a seasoned HVAC technician and conduct maintenance and tune-up for your system. For expert heating repair in Highland Village, TX, contact us.
The Blower Capacitor Went Out of Order
The blower capacitor is that component of the HVAC that starts the furnace once the thermostat instructs it to begin. Each capacitor has its unique tolerance level. If this level is lowered due to some issues, the blower does not achieve the appropriate RPM.
Hence when the capacitor goes out of order, the blower won’t start, and the heater does not radiate the heat. The simple solution to this is the replacement of the capacitor with a new one.
These were the five common problems that you might encounter with your heater Flower Mound. For any assistance related to your heating system, you can contact Honest Home Services LLC.
Visit Our Website To Know More.
